Fibaro Flood Sensor

Fibaro
$135.00
Current Stock:
SKU:
01050008

Description

The FIBARO Flood Sensor is a universal, Z-Wave compatible, flood and temperature sensor. The device can be battery or VDC powered. A flood alarm is sent to the Z-Wave network devices, or additionally to any alarm system controller, through the opening a NC contact.
The device has a built in temperature sensor. The flood Sensor is designed to be placed on the floor or on a wall with a flood sensor probe extended by connected wires. The device has a built in visual LED indicator and an acoustic alarm. An LED diode signals flood, operating mode or the Z-Wave network communication range.
In addition, the sensor is equipped with a tilt sensor reporting tilt or movement to the main controller e.g. when someone has taken the Sensor from its original location
The FIBARO Flood Sensor is sink-proof, which means it drifts on the water surface and keeps on sending the alarm signal in case of a substantial accumulation of water

Features

Compatible with any Z-Wave or Z-Wave+ Controller (firmware 3.2 or higher)
Supports protected mode (Z-Wave network security mode) with AES-128 encryption (firmware 3.2 or higher).
May be connected to any alarm system (potential free output terminal)
Extremely easy installation – simply put on a surface prone to flooding
May be installed anywhere – flood sensor’s contacts extended with a wire
Battery or VDC powered. When connected to an external, 12/24V DC power source, the battery serves as an emergency power source
Theft protection – tilt is reported to the Z-Wave network or alarm system’s main controller
Two operating modes – flood/temperature sensor or just a temperature sensor.
Alarm is signalled by sound, visual indicator (LED diode) and Z-Wave signal
This device may be used with all devices certified with Z-Wave certificate and should be compatible with such devices produced by other manufacturers.
FIBARO Flood Sensor with firmware 3.2 or higher is a Security Enabled Z-Wave Plus product and a Security Enabled Z-Wave Controller must be used in order to fully utilize the product

Technical data

Power supply: Battery or 12–24V DC supply (LPS or NEC class 2)
Battery type: CR123A battery, 3.0V DC
Power consumption (at VDC operation): 0.4W
Output terminals maximum current carrying capacity: (ALARM NC, TAMP NC) 25mA
Maximum voltage at output terminals: (ALARM NC, TAMP NC) 24V DC / 20V AC
Radio protocol: Z-Wave
Z-Wave+ (firmware 3.2 or higher)
Radio frequency: 921.42 MHz
Range: up to 40 m indoors (firmware 3.2 or higher)
Operational temperature: 0°C to 40°C – battery powering mode. -20°C to 70°C – VDC powering mode
Measured temperature range: -20°C to 100°C
Temperature measuring accuracy: 0.5°C (within 0 – 40°C range)
Dimensions (diameter x height): 72 x 28mm
This product is intended to be supplied by a certified Power Supply Unit, marked “Class 2” or “LPS” and rated from 12V DC to 24V DC

Download Operating Manual (1.18Mb)