Fibaro RGBW Controller

Current Stock:


The FIBARO RGBW Controller is a universal, Z-Wave compatible RGB/RGBW controller. The FIBARO RGBW Controller uses PWM output signal, which enables it to control LED, RGB, RGBW strips, halogen lights and fans. Controlled devices may be powered by 12 or 24 VDC. In addition the device supports up to four, 0V – 10V analogue sensors, such as temperature sensors, humidity sensors, wind sensors, air quality sensors, light sensors etc. All IN and OUT terminals may be user configured for LED control or 0V-10V signal readouts.


Compatible with any Z-Wave Controller
Advanced microprocessor control
Different operating modes
Active power and energy metering functionality
Multiple colour pre-sets
Active element: transistor
To be installed in standard wall switch boxes
This device may be used with all devices certified with Z-Wave certificate and should be compatible with such devices produced by other manufacturers.
Supported loads
The FIBARO RGBW Controller may control:
12 / 24VDC powered RGB strips
12 / 24VDC powered RGBW strips
12 / 24VDC powered LED strips, bulbs, etc.
12 / 24VDC powered halogen lights
12 / 24VDC powered low output power fans

Additional features

0-10V sensors signal readouts
0-10V potentiometer signal readouts, and managing outputs accordingly controlled by momentary or toggle switches

Technical data

Power supply: 12/24V DC
Rated output power: combined 12A (sum of all connected output channels) 6A for single output channel
PWM output frequency: 244Hz
Electricity consumption: 0.3W
Radio signal power: 1mW
For installation in boxes: Ø≥50 mm
Max load: at 12V – 144W combined, at 24V – 288W combined
Radio protocol: Z-Wave
Radio frequency: 921.42 MHz
Range: up to 30m indoors
Operational temperature: 0 – 40°C
Dimensions (L x W x H): 42 x 37 x 17 mm

Download Operating Manual (2.7Mb)