PHILIO Z-Wave Smoke Sensor

Current Stock:

Quick Overview



If a fire develops in your home, you can immediately know about it no matter where you are by installing the PHILIO Z-Wave Smoke Sensor. Compatible with any Vera controller, the Smoke Sensor provides both a loud audio alarm and a Z-Wave network alert when smoke is detected. The battery-powered sensor easily mounts to the ceiling with its integrated yet removable bracket. 
FEATURES: Sends system alerts through the Z-Wave network. Can trigger other networked Z-Wave devices. “Z-Wave Plus” certified for wide compatibility. Easy to install with integrated ceiling bracket. Higher output power enhances communication range (+5dBm output power as compared to -2.5dBm 300 series). Low power consumption. Automatic low battery reports. Over-the-air firmware upgrades.

The PHILIO Smoke Sensor is a battery operated Z-Wave Plus ionisation smoke detector. Smoke detection is signaled through siren and LED diode. Additionally, the smoke sensor signal can be sent via Z-Wave gateway to authorised user's smartphones or tablets. The PHILIO  Smoke Sensor is designed to be placed on a ceiling. LED indicator signals fire, operating mode and used to see if device is within the Z-Wave network. The smoke sensor is designed to operate in confined spaces, under normal conditions (lacking smoke, dust, condensed water vapor). Beeping signal warns when the battery needs replacing.
The device has the Z-WaveTM 500 series chip onboard. It is a Z-Wave™ plus product, it supports the security, OTA... Those newest features of the Z-Wave™ technology.

Please note that this smoke sensor can be used only as an auxiliary detector. To fulfil Australian regulation you have to have installed in your dwelling other fully certified in Australia smoke sensors, as a primary smoke detectors. Our Z-Wave smoke sensor can be used only as an additional detector linked to your home automation system. 
This sensor comes with everything you need to install it into an existing Z-Wave network, including mounting screws, drywall anchors, and a CR123A battery for power.

Product Details




  • Compatible with certified Z-Wave controllers in Australian version (921.42MHz) including: VeraEdge UI7 and Fibaro HC2 / Lite.
  • Extremely easy installation - simply install it in location prone to fire.
  • Powered with one CR123A battery (included).
  • Alarm is signaled by loud 85db sound and LED diode.
  • Support the security, OTA.
  • Manual test functionality.
  • NWI automated inclusion functionality.
Product Support



⇒ PHILIO Z-Wave Smoke Sensor Manual (Size: 301KB) 

Technical Specifications


RF protocol
Z-Wave (binary sensor)
Battery Type
One battery CR123A
Operation Range
up to 30m indoor
Radio frequency
921.42 MHz (AU/NZ Z-Wave)
Operation temperature
-10oC ~ 40oC
Application Indoor use only
Size (Diameter)
65 x 28 mm