The Fibaro Swipe is a revolutionary battery gesture control pad that allows you to control devices in your Z-Wave network without actually touching anything. Swipe up, down, left, right, make a circular gesture and use sequences to get full and intuitive control of your home.
The installed device perfectly matches your interior design, as it resembles a picture frame. You can even personalise it with your favourite picture. A gesture controlled menu allows you to add/remove or reset the device without dismounting it.
The device is equipped with a buzzer that confirms performed gestures and other actions.
Compatible with any Z-Wave or Z-Wave+ Controller
Supports protected mode (Z-Wave network security mode) with AES-128 encryption
Allows contact-less gesture detection
Battery and/or VDC powered. When connected to an external, VDC power source, the battery serves as an emergency power source.
Gestures and actions are confirmed by the buzzer and can be indicated additionally by the built-in LED diode.
Gesture controlled menu – allows you to operate the device without dismounting it.
This device may be used with all devices certified with the Z-Wave Plus certificate and should be compatible with such devices produced by other manufacturers.
FIBARO Swipe is a Security Enabled Z-Wave Plus product and a Security Enabled Z-Wave Controller must be used in order to fully utilize the product.
Power supply: 5V DC power supply and/or batteries
Operational current: < 60mA
DC supply connector: micro-USB
Battery type: 4 x 1.5V AA
Radio protocol: Z-Wave (500 series chip)
Radio frequency: 921.42 MHz
Range: up to 40m indoors (depending on building structure)