Fibaro Single Relay Switch

Current Stock:


The FIBARO Single Relay Switch is designed to be installed in standard wall switch boxes or anywhere else where it is necessary to control an electric device drawing up to 2500W.
As with all other Actors, the FIBARO Relay Switch controls connected devices either via the Z-Wave network or via a switch connected directly to it.


Compatible with any Z-Wave Controller
Advanced microprocessor control
Executive element – electromagnetic, micro-gap relay switch
May be oparated by momentary or toggle switches
To be installed in wall switch boxes of dimensions allowing for installation, conforming to provisions of applicable regulations
This device may be used with all devices certified with Z-Wave certificate and should be compatible with such devices produced by other manufacturers.

Technical data

Power supply: 110-240 V AC, 50/60 Hz
Rated load current (resistive load): 10A total current
Power consumption: up to 0.8W
Power output (resistive load): 2500W for 240V AC. 1250W for 120V AC
Operational temperature: 0-35°C
Active element: micro-gap relay switch
Durability (resistive load, 6.5A): 200 000 switches
For installation in boxes: Ø ≥ 50mm, depth ≥ 60mm
Radio protocol: Z-Wave
Radio signal power: up to 1mW
Radio frequency:921.42 MHz
Range: up to 50 m outdoors, up to 30 m indoors (depending on building materials)
Dimensions: (L x W x H): 42.50 x 38.25 x 20.30 mm

Download Operating Manual (1.58Mb)