Fibaro Flood Sensor (Demo Unit - 1 Only)

Current Stock:
FGFS-101 Demo



The FIBARO Flood Sensor is a universal, Z-Wave compatible, flood and temperature sensor. The device can be battery or VDC powered. A flood alarm is sent to the Z-Wave network devices, or additionally to any alarm system controller, through the opening a NC contact.
The device has a built in temperature sensor. The flood Sensor is designed to be placed on the floor or on a wall with a flood sensor probe extended by connected wires. The device has a built in visual LED indicator and an acoustic alarm. An LED diode signals flood, operating mode or the Z-Wave network communication range.
In addition, the sensor is equipped with a tilt sensor reporting tilt or movement to the main controller e.g. when someone has taken the Sensor from its original location
The FIBARO Flood Sensor is sink-proof, which means it drifts on the water surface and keeps on sending the alarm signal in case of a substantial accumulation of water


Compatible with any Z-Wave or Z-Wave+ Controller (firmware 3.2 or higher)
Supports protected mode (Z-Wave network security mode) with AES-128 encryption (firmware 3.2 or higher).
May be connected to any alarm system (potential free output terminal)
Extremely easy installation – simply put on a surface prone to flooding
May be installed anywhere – flood sensor’s contacts extended with a wire
Battery or VDC powered. When connected to an external, 12/24V DC power source, the battery serves as an emergency power source
Theft protection – tilt is reported to the Z-Wave network or alarm system’s main controller
Two operating modes – flood/temperature sensor or just a temperature sensor.
Alarm is signalled by sound, visual indicator (LED diode) and Z-Wave signal
This device may be used with all devices certified with Z-Wave certificate and should be compatible with such devices produced by other manufacturers.
FIBARO Flood Sensor with firmware 3.2 or higher is a Security Enabled Z-Wave Plus product and a Security Enabled Z-Wave Controller must be used in order to fully utilize the product


Technical Specifications


Product Name 
Flood Sensor
Battery Type
Operation Range
12 - 24 VDC (optional)
Radio frequency
921.42 MHz (AU/NZ Z-Wave)
Power Consumption
Operation temperature
0 - 40C*
Measured temperature range -20 to 100C
Temperature measuring accuracy
0,5 C
Size (Diameter x Height)
72 x 28 mm